Nagra Siete TCNagra Seven TCNagra Sete TC

3.507,76  (4.244,39  Imp. Inc.)

grabador digital estereo, 24/192 con AES 42 y memoria interna 16 GB y opción interna código de tiempo
suministrado con:
. batería y cargador
. cable CT QCTCU
. alimentación y manual de instrucciones“Two channel Universal digital audio recorder2 channels & 24 bit, 192 kHz AD / DACompact flash and 16 GB internal Micro SD memoryUSB 2.0 and Ethernet communication portsColour touch-screenLightweight and battery operatedOptional MPEG-1 layer II audio compressionOptional on-board graphic audio editorOptional SMPTE / EBU Time Code or I.S.D.N.”“”

SKU: NA-nagra7 Categoría: Etiquetas: ,

Descripción

Product description:
The Nagra VII (también Nagra Siete, Nagra Sete, Nagra Seven, etc., incluso referido en diversos textos como Nagra 7) has been designed as the successor to the Nagra LB or ARES-C and/or the ARES-BB+ recorders, as well as to fill a gap in the current market. It is designed to be a flexible device:
. base machine is a 2 channel 24-bit digital recorder offering sampling frequencies up to 192 kHz, and is equipped with AES 42 facilities for digital microphones,
. sizes are similar to the LB,
and can be adapted to a multitude of specific applications depending on the internal options installed to allow it to be adapted according to requirements:
. hardware options: consist of 3G and Wifi, SMPTE/EBU time code and ISDN communication possibilities.
. software options: for internal audio editing and audio compression.

Audio inputs:
The Nagra VII offers two analogue audio inputs and a single stereo digital input. It will record in PCM linear audio at sampling frequencies up to 192 kHz or in MPEG-1 layer II compressed audio formats if the compression option is installed. The inputs are equipped with traditional Nagra microphone pre-amplifiers for dynamic and phantom +48V microphones and offer a range of switchable sensitivities to accomadate all common microphones. AES-42 microphones can also be used as the recorder can supply the necessary 10V dc supply voltage on the AES input.

The analogue LINE input will accept up to +24dB allowing it to be connected to a standard audio mixer in the field.

Touchscreen:
The Nagra Siete has a state-of-the-art colour touchscreen allowing greater flexibility in the display modes and screens, but also eliminating all switches which are the weakest link in modern electronics.
The audio levels, current operating mode and status of the recorder are shown on the touchscreen display mounted on the front of the unit. The screen is sunlight readable, and gives access to the entire menu structure of the recorder.

Various programmable “short cuts” are available giving many personalization possibilities.

Media:
The Nagra Seven is fitted with an internal micro SD flash memory. The main extractable media is an SD memory card which inserts into the slot on the left side of the recorder (see picture above).

USB 2.0 port:
A micro-AB USB port allows the unit to be connected to a computer for file transfer. With an interface adaptor, the same port can also be used to connect an external device such as a USB memory stick or computer keyboard for data entry.

Editing and communication:
If the optional editing option is installed, then graphic editing of the audio files is possible on the main display. Once the editing of the audio material is complete, files can be transmitted to the studio either over IP (through the ethernet connection using the File Transfer Protocol “FTP” connection) or via a GSM phone using 3G or by Wifi (if the option is installed).

SMPTE / EBU Time code:
The Nagra Siete has an optional internal time code board that works with all currently accepted frame rates including those for HD TV. It will handle both drop and non-drop frame rates, and will allow pull-up/down too.

Start / Stop:
A 3.5mm miniature Jack socket is fitted for remote fader start/stop commands. This will allow the unit to be remotely controlled by a simple switch closure.

Powering:
The Nagra VII powered by a lithium-ion rechargeable battery pack, that will power the unit for about 5 hours. However, if transmission options such as WiFi or 3G are used the battery life will be reduced. 2

Delivery variants, Scope of suplly:

Nagra VII: Stereo digital recorder, 24/192 with AES 42 and internal 16GB memory delivered with: Battery box and charger, power supply, and Instruction manual.

Nagra VII TC: Stereo digital recorder, 24/192 with AES 42, internal 16GB memory and internal Time Code option delivered with: Battery box and charger, power supply, QCTCU time code cable and Instruction manual.

Nagra VII W3: Stereo digital recorder, 24/192 with AES 42,internal 16GB memory, internal WiFi /3G option delivered with: Battery box and charger, power supply, WiFi antenna, and Instruction manual.

Nagra VII ISDN: Stereo digital recorder, 24/192 with AES 42 internal 16GB memory and internal I.S.D.N. codec and audio compression, delivered with:Battery box and charger, power supply and Instruction manual.

Nagra VII ISDN W3: Stereo digital recorder, 24/192 with AES 42 internal 16GB memory and internal I.S.D.N. codec, audio compression and Wifi / 3G option, delivered with:Battery box and charger, power supply, Wifi antenna and Instruction manual. 3,393.36

Datos Técnicos

Recording

Internal storage

MicroSD flash memory card

Removable media

SD flash memory card

Disk format

FAT 16 / 32

Recording Method

linear digital PCM & optional: MPEG 1 layer II

File type

16 & 24 bit Broadcast Wave File BWF (WAV)

A/D & D/A conversion

24 Bit Sigma Delta

Bit rates

32 kbits/s up to 384 kbits/sec

Tracks

2 individual

Sampling Rate

44.1, 48, 88.2, 96, 176.4 and 192 kHz

Recording capacity

1 h at 24 bit 48 kHz per GB of memory

Pre-recording buffer

programmable

Display

colour LCD touchscreen

Level meters

on colour display

Inputs

Digital input

XLR 3-pole, AES 42

Analogue inputs

2 x XLR microphone, (dynamic, +48dV phantom) or line

Microphone input sensitivity

2.8, 10 and 40 mV/Pa selectable

Mic input noise

Uin

Uin

Limiters

on microphone inputs

Line input sensitivity

adjustable from -6 dBm up to +24 dBm for 0 dBFS recording

THD at 1 kHz

2.8 mV Mic

Frequency response

mic: 10 Hz-75 kHz (+0 – 3 dB);

line: 10 Hz-90 kHz (+0 -1 dB) (measured on AES out)

Signal-to-noise ratio

>110 dB ASA “A”

Input level adjustment range

mic: 45 dB; line: from -6 to +24 dB

Input filters

LFA

Internal microphone

on the front panel

Crosstalk

mic >70 dB; Line >110 dB

Outputs

Analogue line output

XLR 4.4 Vmax (+15 dBm)

Crosstalk

>110 dB

Signal-to-noise ratio

>100 dB

Digital output

XLR AES-3 (24 bit or 16 bit)

THD+N

Frequency response

10 Hz – 75 kHz (+0-3dB)

Headphones

stereo 6.3 mm (¼”) jack, 50 Ω

Internal speaker

0.3 W

Other

USB

micro AB connector

M/S Decoder

switchable

Ethernet

RJ 45

General

Dimensions

165 x 175 x 65mm (W x H x D), incl. battery box

Weight

800 g (1.75 lbs), incl. battery pack

Power supply

external 15 V

Power Consumption

approximately 5W

Charge time

approximately 3 hours

Battery life

>5 h

Relative humidity

from 10 % to 99 % (non condensing)

especificaciones sujetas a cambios sin previo aviso

Preguntas Frecuentes

Description

Product description:
The Nagra VII (también Nagra Siete, Nagra Sete, Nagra Seven, etc., incluso referido en diversos textos como Nagra 7) has been designed as the successor to the Nagra LB, ARES-C and the ARES-BB+ recorders, as well as to fill a gap in the current market. It is designed to be a flexible device and can be adapted to a multitude of specific applications depending on the internal options installed. The base machine is a 2 channel 24-bit digital recorder offering sampling frequencies up to 192 kHz, and is equipped with AES 42 facilities for digital microphones. Similar in size to the LB, the Seven offers a selection of internal optional circuit cards to allow it to be adapted according to requirements. The hardware options consist of 3G and Wifi, SMPTE/EBU time code and ISDN communication possibilities. In addition there are software options for internal audio editing and audio compression.

Audio inputs:
The Nagra VII offers two analogue audio inputs and a single stereo digital input. It will record in PCM linear audio at sampling frequencies up to 192 kHz or in MPEG-1 layer II compressed audio formats if the compression option is installed. The inputs are equipped with traditional Nagra microphone pre-amplifiers for dynamic and phantom +48V microphones and offer a range of switchable sensitivities to accomadate all common microphones. AES-42 microphones can also be used as the recorder can supply the necessary 10V dc supply voltage on the AES input.

The analogue LINE input will accept up to +24dB allowing it to be connected to a standard audio mixer in the field.

Touchscreen:
The Nagra Seven has a state-of-the-art colour touchscreen allowing greater flexibility in the display modes and screens, but also eliminating all switches which are the weakest link in modern electronics.
The audio levels, current operating mode and status of the recorder are shown on the touchscreen display mounted on the front of the unit. The screen is sunlight readable, and gives access to the entire menu structure of the recorder.

Various programmable “short cuts” are available giving many personalization possibilities.

Media:
The Nagra Seven is fitted with an internal micro SD flash memory. The main extractable media is an SD memory card which inserts into the slot on the left side of the recorder (see picture above).

USB 2.0 port:
A micro-AB USB port allows the unit to be connected to a computer for file transfer. With an interface adaptor, the same port can also be used to connect an external device such as a USB memory stick or computer keyboard for data entry.

Editing and communication:
If the optional editing option is installed, then graphic editing of the audio files is possible on the main display. Once the editing of the audio material is complete, files can be transmitted to the studio either over IP (through the ethernet connection using the File Transfer Protocol “FTP” connection) or via a GSM phone using 3G or by Wifi (if the option is installed).

SMPTE / EBU Time code:
The Nagra Seven has an optional internal time code board that works with all currently accepted frame rates including those for HD TV. It will handle both drop and non-drop frame rates, and will allow pull-up/down too.

Start / Stop:
A 3.5mm miniature Jack socket is fitted for remote fader start/stop commands. This will allow the unit to be remotely controlled by a simple switch closure.

Powering:
The Nagra VII powered by a lithium-ion rechargeable battery pack, that will power the unit for about 5 hours. However, if transmission options such as WiFi or 3G are used the battery life will be reduced.

Technical Specifications

Recording

Internal storage

MIcro SD Flash memory card

Removable media

SD Flash memorycard

Disk format

FAT 16 / 32

Recording Method

Linear digital PCM, optional:MPEG 1 layer II

File type

16 / 24 bit Broadcast Wave File BWF (WAV)

A/D & D/A conversion

24 Bit Sigma Delta

Bit rates

32 kbits/s up to 384 kbits/sec

Tracks

2 individual

Sampling Rate

44.1, 48 kHz, 88.2, 96, 176.4 and 192kHz

Recording capacity

1hr at 24 bit 48 kHz per GB of memory

Pre-recording buffer

Programmable

Display

Colour LCD touchscreen

Level meters

On colour display

Inputs

Digital input

XLR 3-pole / AES 42

Analogue inputs

2 x XLR Microphone (Dynamic, +48V Phantom) / line

Microphone input sensitivity

2.8, 10 and 40 mV/Pa selectable

Mic input noise

Uin < 1µV (2.8 and 10 mV) @ 220Ω

Uin < 1.6µV (40 mV)

Limiters

On microphone inputs

Line input sensitivity

Adjustable from -6 dBm up to +24 dBm for 0 dBFS recording

THD at 1 kHz

2.8mV Mic <0.2%, 10mV Mic <0.1%, line <0.1% (measured on AES out)

Frequency response

Mic, 10Hz – 75 kHz (+0 – 3dB), Line 10 Hz – 90 kHz (+0 -1dB) (measured on AES out)

Signal-to-noise ratio

>110 dB ASA “A”

Input level adjustment range

45 dB Mic and from -6 to +24 dB Line

Input filters

LFA

Internal microphone

On the front panel

Crosstalk

Mic >70dB : Line > 110dB

Outputs

Analogue line output

XLR 4.4V max (+15 dBm)

Crosstalk

>110 dB

Signal-to-noise ratio

>100 dB

Digital output

XLR AES-3 (24 bit or 16 bit)

THD+N

<0.004%

Frequency response

10 Hz – 75 kHz (+0-3dB)

Headphones

Stereo 6.3mm (¼”) Jack 50 Ω

Internal speaker

0.3W

Other

USB

Micro AB connector

M/S Decoder

Switchable

Ethernet

RJ 45

General

Dimensions

165 x 175 x 65mm (W x H x D) (Incl. battery box)

Weight

800g (1.75 lbs) (Incl. battery pack)

Power supply

External 15V

Power Consumption

Approximately 5W

Charge time

Approximately 3 hours

Battery life

>5 hours

Relative humidity

From 10% to 99% (non condensing)

especificaciones sujetas a cambios sin previo aviso

FAQ

Descrição

Especificações Técnicas

Preguntas Frecuentes

Información adicional

Marca

Valoraciones

No hay valoraciones aún.

Solo los usuarios registrados que hayan comprado este producto pueden hacer una valoración.

Free Divi WordPress Theme, Find new Free Android Games at dlandroid24.com